Command Reference Guide

Port Configuration Commands
CLI Command Reference
September 2014 Page 274
HP Moonshot Switch Module CLI Command Reference
show port description
This command displays the interface description. Instead of unit/slot/port, lag lag-intf-num can be used as
an alternate way to specify the LAG interface.
lag lag-intf-num can also be used to specify the LAG interface
where
lag-intf-num is the LAG port number.
Example: The following shows example CLI display output for the command.
(Routing) #show port description 1/0/1
Interface...........1/0/1
ifIndex.............1
Description.........
MAC address.........00:10:18:82:0C:10
Bit Offset Val......1
Format
show port description unit/slot/port
Mode Privileged EXEC
Term Definition
Interface unit/slot/port
ifIndex The interface index number associated with the port.
Description The alpha-numeric description of the interface created by the command “description” on
page 270.
MAC address The MAC address of the port. The format is 6 two-digit hexadecimal numbers that are
separated by colons, for example 01:23:45:67:89:AB.
Bit Offset Val The bit offset value.