Command Reference Guide

Spanning Tree Protocol Commands
CLI Command Reference
September 2014 Page 278
HP Moonshot Switch Module CLI Command Reference
no spanning-tree configuration name
This command resets the Configuration Identifier Name to its default.
spanning-tree configuration revision
This command sets the Configuration Identifier Revision Level for use in identifying the configuration that this
switch is currently using. The Configuration Identifier Revision Level is a number in the range of 0 to 65535.
no spanning-tree configuration revision
This command sets the Configuration Identifier Revision Level for use in identifying the configuration that this
switch is currently using to the default value.
spanning-tree cost
Use this command to configure the external path cost for port used by a MST instance. When the auto keyword
is used, the path cost from the port to the root bridge is automatically determined by the speed of the
interface. To configure the cost manually, specify a
cost value from 1– 200000000.
no spanning-tree cost
This command resets the auto-edge status of the port to the default value.
Format
no spanning-tree configuration name
Mode Global Config
Default 0
Format
spanning-tree configuration revision 0-65535
Mode Global Config
Format
no spanning-tree configuration revision
Mode Global Config
Default auto
Format
spanning-tree cost {cost | auto}
Mode Interface Config
Format
no spanning-tree cost
Mode Interface Config