Command Reference Guide

Spanning Tree Protocol Commands
CLI Command Reference
September 2014 Page 279
HP Moonshot Switch Module CLI Command Reference
spanning-tree edgeport
This command specifies that an interface (or range of interfaces) is an Edge Port within the common and
internal spanning tree. This allows this port to transition to Forwarding State without delay.
no spanning-tree edgeport
This command specifies that this port is not an Edge Port within the common and internal spanning tree.
spanning-tree forceversion
This command sets the Force Protocol Version parameter to a new value.
• Use 802.1d to specify that the switch transmits ST BPDUs rather than MST BPDUs (IEEE 802.1d
functionality supported).
• Use 802.1s to specify that the switch transmits MST BPDUs (IEEE 802.1s functionality supported).
• Use 802.1w to specify that the switch transmits RST BPDUs rather than MST BPDUs (IEEE 802.1w
functionality supported).
no spanning-tree forceversion
This command sets the Force Protocol Version parameter to the default value.
Format
spanning-tree edgeport
Mode Interface Config
Format
no spanning-tree edgeport
Mode Interface Config
Default 802.1w
Format
spanning-tree forceversion {802.1d | 802.1s | 802.1w}
Mode Global Config
Format
no spanning-tree forceversion
Mode Global Config