Command Reference Guide

Switch Stacking
CLI Command Reference
September 2014 Page 28
HP Moonshot Switch Module CLI Command Reference
no set slot disable
This command unconfigures the administrative mode of the slot(s). If you specify all, the command removes
the configuration from all slots, otherwise the configuration is removed from the slot identified by
unit/slot.
If a card or other module is present in the slot, this administrative mode removes the configuration from the
contents of the slot. If the slot is empty, this administrative mode removes the configuration from any module
inserted into the slot. If a card is disabled, all the ports on the device are operationally disabled and shown as
“unplugged” on management screens.
set slot power
This command configures the power mode of the slot(s) and allows power to be supplied to a card located in
the slot. If you specify
all, the command is applied to all slots, otherwise the command is applied to the slot
identified by
unit/slot.
Use this command when installing or removing cards. If a card or other module is present in this slot, the power
mode is applied to the contents of the slot. If the slot is empty, the power mode is applied to any card inserted
into the slot.
no set slot power
This command unconfigures the power mode of the slot(s) and prohibits power from being supplied to a card
located in the slot. If you specify
all, the command prohibits power to all slots, otherwise the command
prohibits power to the slot identified by
unit/slot.
Use this command when installing or removing cards. If a card or other module is present in this slot, power is
prohibited to the contents of the slot. If the slot is empty, power is prohibited to any card inserted into the slot.
reload (Stack)
This command resets the entire stack or the identified unit. The unit is the switch identifier. The system
prompts you to confirm that you want to reset the switch.
Format
no set slot disable [unit/slot] | all]
Mode Global Config
Format
set slot power [unit/slot] | all]
Mode Global Config
Format
no set slot power [unit/slot] | all]
Mode Global Config
Format
reload [unit]
Mode Privileged EXEC