Command Reference Guide

Spanning Tree Protocol Commands
CLI Command Reference
September 2014 Page 285
HP Moonshot Switch Module CLI Command Reference
no spanning-tree port mode all
This command sets the Administrative Switch Port State for all ports to disabled.
spanning-tree tcnguard
Use this command to enable TCN guard on the interface. When enabled, TCN Guard restricts the interface from
propagating any topology change information received through that interface.
no spanning-tree tcnguard
This command resets the TCN guard status of the port to the default value.
spanning-tree transmit
This command sets the Bridge Transmit Hold Count parameter.
Format
no spanning-tree port mode all
Mode Global Config
Default Enabled
Format
spanning-tree tcnguard
Mode Interface Config
Format
no spanning-tree tcnguard
Mode Interface Config
Default
6
Format
spanning-tree transmit hold-count
Mode Global Config
Parameter Description
hold-count The Bridge Tx hold-count parameter. The value in an integer between 1 and 10.