Command Reference Guide

Switch Stacking
CLI Command Reference
September 2014 Page 30
HP Moonshot Switch Module CLI Command Reference
show supported cardtype
This commands displays information about all card types or specific card types supported in the system.
If you do not supply a value for
cardindex, the following output appears:
If you supply a value for
cardindex, the following output appears:
show switch
This command displays switch status information about all units in the stack or a single unit when you specify
the unit value.
When you do not specify a value for
unit, the following information appears:
Format
show supported cardtype [cardindex]
Mode User EXEC
Term Definition
Card Index (CID) The index into the database of the supported card types. This index is used when
preconfiguring a slot.
Card Model
Identifier
The model identifier for the supported card type.
Term Definition
Card Type The 32-bit numeric card type for the supported card.
Model Identifier The model identifier for the supported card type.
Card Description The description for the supported card type.
Format
show switch [unit]
Mode Privileged EXEC
Term Definition
Switch The unit identifier assigned to the switch.
Term Definition
Management
Switch
Indicates whether the switch is the Primary Management Unit, a stack member, a
configured standby switch, an operational standby switch, or the status is unassigned.
Standby Status Indicates whether the switch a configured or operational standby switch.
Preconfigured
Model Identifier
The model identifier of a preconfigured switch ready to join the stack. The Model Identifier
is a 32-character field assigned by the device manufacturer to identify the device.