Command Reference Guide

VLAN Commands
CLI Command Reference
September 2014 Page 305
HP Moonshot Switch Module CLI Command Reference
vlan protocol group add protocol
This command adds the protocol to the protocol-based VLAN identified by groupid. A group may have more
than one protocol associated with it. Each interface and protocol combination can only be associated with one
group. If adding a protocol to a group causes any conflicts with interfaces currently associated with the group,
this command fails and the protocol is not added to the group. The possible values for protocol are
The
possible values for protocol-list includes the keywords
ip, arp, and ipx and hexadecimal or decimal values
ranging from 0x0600 (1536) to 0xFFFF (65535). The protocol list can accept up to 16 protocols separated by a
comma.
no vlan protocol group add protocol
This command removes the protocols specified in the protocol-list from this protocol-based VLAN group
that is identified by this
groupid.
protocol group
This command attaches a vlanid to the protocol-based VLAN identified by groupid. A group may only be
associated with one VLAN at a time, however the VLAN association can be changed.
no protocol group
This command removes the vlanid from this protocol-based VLAN group that is identified by this groupid.
Default none
Format
vlan protocol group add protocol groupid ethertype protocol-list
Mode Global Config
Format
no vlan protocol group add protocol groupid ethertype protocol-list
Mode Global Config
Default none
Format
protocol group groupid vlanid
Mode VLAN Config
Format
no protocol group groupid vlanid
Mode VLAN Config