Command Reference Guide

VLAN Commands
CLI Command Reference
September 2014 Page 306
HP Moonshot Switch Module CLI Command Reference
protocol vlan group
This command adds a physical interface or a range of interfaces to the protocol-based VLAN identified by
groupid. You can associate multiple interfaces with a group, but you can only associate each interface and
protocol combination with one group. If adding an interface to a group causes any conflicts with protocols
currently associated with the group, this command fails and the interface(s) are not added to the group.
no protocol vlan group
This command removes the interface from this protocol-based VLAN group that is identified by this groupid.
protocol vlan group all
This command adds all physical interfaces to the protocol-based VLAN identified by groupid. You can associate
multiple interfaces with a group, but you can only associate each interface and protocol combination with one
group. If adding an interface to a group causes any conflicts with protocols currently associated with the group,
this command will fail and the interface(s) will not be added to the group.
no protocol vlan group all
This command removes all interfaces from this protocol-based VLAN group that is identified by this groupid.
Default none
Format
protocol vlan group groupid
Mode Interface Config
Format
no protocol vlan group groupid
Mode Interface Config
Default none
Format
protocol vlan group all groupid
Mode Global Config
Format
no protocol vlan group all groupid
Mode Global Config