Command Reference Guide

VLAN Commands
CLI Command Reference
September 2014 Page 307
HP Moonshot Switch Module CLI Command Reference
show port protocol
This command displays the Protocol-Based VLAN information for either the entire system, or for the indicated
group.
vlan pvid
This command changes the VLAN ID on an interface or range of interfaces.
no vlan pvid
This command sets the VLAN ID on an interface or range of interfaces to 1.
vlan tagging
This command configures the tagging behavior for a specific interface or range of interfaces in a VLAN to
enabled. If tagging is enabled, traffic is transmitted as tagged frames. If tagging is disabled, traffic is transmitted
as untagged frames. The ID is a valid VLAN identification number.
Format
show port protocol {groupid | all}
Mode Privileged EXEC
Term Definition
Group Name The group name of an entry in the Protocol-based VLAN table.
Group ID The group identifier of the protocol group.
VLAN The VLAN associated with this Protocol Group.
Protocol(s) The type of protocol(s) for this group.
Interface(s) Lists the
unit/slot/port interface(s) that are associated with this Protocol Group.
Default 1
Format
vlan pvid 1-4093
Mode Interface Config
Interface Range Config
Format
no vlan pvid
Mode Interface Config
Format
vlan tagging 1-4093
Mode •Interface Config