Command Reference Guide

Double VLAN Commands
CLI Command Reference
September 2014 Page 314
HP Moonshot Switch Module CLI Command Reference
no dvlan-tunnel ethertype default–tpid
Use the no form of the command to set the TPID register to 0. (At initialization, all TPID registers will be set to
their default values.)
mode dot1q-tunnel
This command is used to enable Double VLAN Tunneling on the specified interface.
no mode dot1q-tunnel
This command is used to disable Double VLAN Tunneling on the specified interface. By default, Double VLAN
Tunneling is disabled.
mode dvlan-tunnel
Use this command to enable Double VLAN Tunneling on the specified interface.
no mode dvlan-tunnel
This command is used to disable Double VLAN Tunneling on the specified interface. By default, Double VLAN
Tunneling is disabled.
Format
no dvlan-tunnel ethertype {802.1Q | vman | custom 0–65535} [default-tpid]
Mode Global Config
Default disabled
Format
mode dot1q-tunnel
Mode Interface Config
Format
no mode dot1q-tunnel
Mode Interface Config
Note: When you use the mode dvlan-tunnel command on an interface, it becomes a service provider
port. Ports that do not have double VLAN tunneling enabled are customer ports.
Default disabled
Format
mode dvlan-tunnel
Mode Interface Config
Format
no mode dvlan-tunnel
Mode Interface Config