Command Reference Guide

Private VLAN Commands
CLI Command Reference
September 2014 Page 318
HP Moonshot Switch Module CLI Command Reference
switchport mode private-vlan
This command configures a port as a promiscuous or host private VLAN port. Note that the properties of each
mode can be configured even when the switch is not in that mode. However, they will only be applicable once
the switch is in that particular mode.
no switchport mode private-vlan
This command removes the private-VLAN association or mapping from the port.
private-vlan
This command configures the private VLANs and configures the association between the primary private VLAN
and secondary VLANs.
Default
general
Format
switchport mode private-vlan {host|promiscuous}
Mode Interface Config
Parameter Description
host Configures an interface as a private VLAN host port. It can be either isolated or community
port depending on the secondary VLAN it is associated with.
promiscuous Configures an interface as a private VLAN promiscuous port. The promiscuous ports are
members of the primary VLAN.
Format
no switchport mode private-vlan
Mode Interface Config
Format
private-vlan {association [add|remove] secondary-vlan-
list|community|isolated|primary}
Mode VLAN Config
Parameter Description
association Associates the primary and secondary VLAN.
secondary-vlan-list A list of secondary VLANs to be mapped to a primary VLAN.
community Designates a VLAN as a community VLAN.
isolated Designates a VLAN as the isolated VLAN.
primary Designates a VLAN as the primary VLAN.