Command Reference Guide

Asymmetric Flow Control
CLI Command Reference
September 2014 Page 323
HP Moonshot Switch Module CLI Command Reference
show flowcontrol
Use this command to display the IEEE 802.3 Annex 31B flow control settings and status for a specific interface
or all interfaces. The command also displays 802.3 Tx and Rx pause counts. Priority Flow Control frames counts
are not displayed. If the port is enabled for priority flow control, operational flow control status is displayed as
Inactive. Operational flow control status for stacking ports is always displayed as N/A.
Example: The following shows example CLI display output for the command.
(Routing) #show flowcontrol
Admin Flow Control: Inactive
Flow Control Flow Control RxPause TxPause
Intf Oper Mode
------- ------------ ------------ -------- --------
1/0/1 Inactive Disable 0 0
1/0/2 Inactive Disable 0 0
1/0/3 Inactive Disable 0 0
1/0/4 Inactive Disable 0 0
1/0/5 Inactive Disable 0 0
1/0/6 Inactive Disable 0 0
1/0/7 Inactive Disable 0 0
1/0/8 Inactive Disable 0 0
Format
show flowcontrol [unit/slot/port]
Mode Privileged Exec
Term Definition
Admin Flow Control The administrative mode of 802.3 flow control on the switch.
Intf The interface associated with the rest of the data in the row.
Flow Control Oper The operational mode of 802.3 flow control on the interface, which is either active or
inactive.
Flow Control Mode The administrative mode of 802.3 flow control on the interface.
RxPause The number of pause frames received by the interface.
TxPause The number of pause frames the interface has transmitted.