Command Reference Guide

GARP Commands
CLI Command Reference
September 2014 Page 326
HP Moonshot Switch Module CLI Command Reference
show interfaces switchport
This command displays the status of the interface (protected/unprotected) under the groupid.
GARP Commands
This section describes the commands you use to configure Generic Attribute Registration Protocol (GARP) and
view GARP status. The commands in this section affect both GARP VLAN Registration Protocol (GVRP) and
GARP Multicast Registration Protocol (GMRP). GARP is a protocol that allows client stations to register with the
switch for membership in VLANS (by using GVMP) or multicast groups (by using GVMP).
set garp timer join
This command sets the GVRP join time per GARP for one interface, a range of interfaces, or all interfaces. Join
time is the interval between the transmission of GARP Protocol Data Units (PDUs) registering (or re-registering)
membership for a VLAN or multicast group. This command has an effect only when GVRP is enabled. The time
is from 10 to 100 (centiseconds). The value 20 centiseconds is 0.2 seconds.
no set garp timer join
This command sets the GVRP join time to the default and only has an effect when GVRP is enabled.
Format
show interfaces switchport unit/slot/port groupid
Mode •Privileged EXEC
• User EXEC
Term Definition
Protected Port Indicates whether the interface is protected or not. It shows TRUE or FALSE. If the group is
a multiple groups then it shows TRUE in Group
groupid.
Default 20
Format
set garp timer join 10-100
Mode •Interface Config
• Global Config
Format
no set garp timer join
Mode •Interface Config
• Global Config