Command Reference Guide

GARP Commands
CLI Command Reference
September 2014 Page 327
HP Moonshot Switch Module CLI Command Reference
set garp timer leave
This command sets the GVRP leave time for one interface, a range of interfaces, or all interfaces or all ports and
only has an effect when GVRP is enabled. Leave time is the time to wait after receiving an unregister request
for a VLAN or a multicast group before deleting the VLAN entry. This can be considered a buffer time for
another station to assert registration for the same attribute in order to maintain uninterrupted service. The
leave time is 20 to 600 (centiseconds). The value 60 centiseconds is 0.6 seconds. The leave time must be greater
than or equal to three times the join time.
no set garp timer leave
This command sets the GVRP leave time on all ports or a single port to the default and only has an effect when
GVRP is enabled.
set garp timer leaveall
This command sets how frequently Leave All PDUs are generated. A Leave All PDU indicates that all
registrations will be unregistered. Participants would need to rejoin in order to maintain registration. The value
applies per port and per GARP participation. The time may range from 200 to 6000 (centiseconds). The value
1000 centiseconds is 10 seconds. You can use this command on all ports (Global Config mode), or on a single
port or a range of ports (Interface Config mode) and it only has an effect only when GVRP is enabled. The leave
all time must be greater than the leave time.
no set garp timer leaveall
This command sets how frequently Leave All PDUs are generated the default and only has an effect when GVRP
is enabled.
Default 60
Format
set garp timer leave 20-600
Mode •Interface Config
• Global Config
Format
no set garp timer leave
Mode •Interface Config
• Global Config
Default 1000
Format
set garp timer leaveall 200-6000
Mode •Interface Config
• Global Config
Format
no set garp timer leaveall
Mode •Interface Config
• Global Config