Command Reference Guide

GVRP Commands
CLI Command Reference
September 2014 Page 329
HP Moonshot Switch Module CLI Command Reference
set gvrp interfacemode
This command enables GVRP on a single port (Interface Config mode), a range of ports (Interface Range mode),
or all ports (Global Config mode).
no set gvrp interfacemode
This command disables GVRP on a single port (Interface Config mode) or all ports (Global Config mode). If GVRP
is disabled, Join Time, Leave Time and Leave All Time have no effect.
show gvrp configuration
This command displays Generic Attributes Registration Protocol (GARP) information for one or all interfaces.
Default disabled
Format
set gvrp interfacemode
Mode •Interface Config
•Interface Range
• Global Config
Format
no set gvrp interfacemode
Mode •Interface Config
• Global Config
Format
show gvrp configuration {unit/slot/port | all}
Mode •Privileged EXEC
• User EXEC
Term Definition
Interface unit/slot/port
Join Timer The interval between the transmission of GARP PDUs registering (or re-registering)
membership for an attribute. Current attributes are a VLAN or multicast group. There is an
instance of this timer on a per-Port, per-GARP participant basis. Permissible values are 10
to 100 centiseconds (0.1 to 1.0 seconds). The factory default is 20 centiseconds (0.2
seconds). The finest granularity of specification is one centisecond (0.01 seconds).
Leave Timer The period of time to wait after receiving an unregister request for an attribute before
deleting the attribute. Current attributes are a VLAN or multicast group. This may be
considered a buffer time for another station to assert registration for the same attribute in
order to maintain uninterrupted service. There is an instance of this timer on a per-Port,
per-GARP participant basis. Permissible values are 20 to 600 centiseconds (0.2 to 6.0
seconds). The factory default is 60 centiseconds (0.6 seconds).