Command Reference Guide

Port-Based Network Access Control Commands
CLI Command Reference
September 2014 Page 335
HP Moonshot Switch Module CLI Command Reference
dot1x guest-vlan
This command configures VLAN as guest vlan on an interface or a range of interfaces. The command specifies
an active VLAN as an IEEE 802.1X guest VLAN. The range is 1 to the maximum VLAN ID supported by the
platform.
no dot1x guest-vlan
This command disables Guest VLAN on the interface.
dot1x initialize
This command begins the initialization sequence on the specified port. This command is only valid if the control
mode for the specified port is auto or mac-based. If the control mode is not auto or mac-based, an error will
be returned.
dot1x max-req
This command sets the maximum number of times the authenticator state machine on an interface or range
of interfaces will transmit an EAPOL EAP Request/Identity frame before timing out the supplicant. The
count
value must be in the range 1 - 10.
no dot1x max-req
This command sets the maximum number of times the authenticator state machine on this port will transmit
an EAPOL EAP Request/Identity frame before timing out the supplicant.
Default disabled
Format
dot1x guest-vlan vlan-id
Mode Interface Config
Default disabled
Format
no dot1x guest-vlan
Mode Interface Config
Format
dot1x initialize unit/slot/port
Mode Privileged EXEC
Default 2
Format
dot1x max-req count
Mode Interface Config
Format
no dot1x max-req
Mode Interface Config