Command Reference Guide

Port-Based Network Access Control Commands
CLI Command Reference
September 2014 Page 336
HP Moonshot Switch Module CLI Command Reference
dot1x max-users
Use this command to set the maximum number of clients supported on an interface or range of interfaces
when MAC-based dot1x authentication is enabled on the port. The maximum users supported per port is
dependent on the product. The
count value is in the range 1 - 48.
no dot1x max-users
This command resets the maximum number of clients allowed per port to its default value.
dot1x port-control
This command sets the authentication mode to use on the specified interface or range of interfaces. Use the
force-unauthorized parameter to specify that the authenticator PAE unconditionally sets the controlled port
to unauthorized. Use the
force-authorized parameter to specify that the authenticator PAE unconditionally
sets the controlled port to authorized. Use the
auto parameter to specify that the authenticator PAE sets the
controlled port mode to reflect the outcome of the authentication exchanges between the supplicant,
authenticator and the authentication server. If the
mac-based option is specified, then MAC-based dot1x
authentication is enabled on the port.
no dot1x port-control
This command sets the 802.1X port control mode on the specified port to the default value.
Default 48
Format
dot1x max-users count
Mode Interface Config
Format
no dot1x max-users
Mode Interface Config
Default auto
Format
dot1x port-control {force-unauthorized | force-authorized | auto | mac-based}
Mode Interface Config
Format
no dot1x port-control
Mode Interface Config