Command Reference Guide

Port-Based Network Access Control Commands
CLI Command Reference
September 2014 Page 338
HP Moonshot Switch Module CLI Command Reference
dot1x re-authenticate
This command begins the re-authentication sequence on the specified port. This command is only valid if the
control mode for the specified port is auto or mac-based. If the control mode is not auto or mac-based, an
error will be returned.
dot1x re-authentication
This command enables re-authentication of the supplicant for the specified interface or range of interfaces.
no dot1x re-authentication
This command disables re-authentication of the supplicant for the specified port.
dot1x system-auth-control
Use this command to enable the dot1x authentication support on the switch. While disabled, the dot1x
configuration is retained and can be changed, but is not activated.
no dot1x system-auth-control
This command is used to disable the dot1x authentication support on the switch.
Format
dot1x re-authenticate unit/slot/port
Mode Privileged EXEC
Default disabled
Format
dot1x re-authentication
Mode Interface Config
Format
no dot1x re-authentication
Mode Interface Config
Default disabled
Format
dot1x system-auth-control
Mode Global Config
Format
no dot1x system-auth-control
Mode Global Config