Command Reference Guide

Stack Port Commands
CLI Command Reference
September 2014 Page 34
HP Moonshot Switch Module CLI Command Reference
show stack-port counters
This command displays summary data counter information for all interfaces.
show stack-port diag
This command shows stack port diagnostics for each port and is only intended for Field Application Engineers
(FAEs) and developers. An FAE will advise on the necessity to run this command and capture this information.
show stack-port stack-path
This command displays the route a packet will take to reach the destination.
Format
show stack-port counters
Mode Privileged EXEC
Term Definition
Unit The unit number.
Interface The slot and port numbers.
Tx Data Rate Trashing data rate in megabits per second on the stacking port.
Tx Error Rate Platform-specific number of transmit errors per second.
Tx Total Errors Platform-specific number of total transmit errors since power-up.
Rx Data Rate Receive data rate in megabits per second on the stacking port.
Rx Error Rate Platform-specific number of receive errors per second.
Rx Total Errors Platform-specific number of total receive errors since power-up.
Format
show stack-port diag
Mode Privileged EXEC
Term Definition
Unit The unit number.
Interface The slot and port numbers.
Diagnostic Entry1 80 character string used for diagnostics.
Diagnostic Entry2 80 character string used for diagnostics.
Diagnostic Entry3 80 character string used for diagnostics.
Format
show stack-port stack-path {1—9 | all}
Mode Privileged EXEC