Command Reference Guide

Port-Based Network Access Control Commands
CLI Command Reference
September 2014 Page 340
HP Moonshot Switch Module CLI Command Reference
no dot1x timeout
This command sets the value, in seconds, of the timer used by the authenticator state machine on this port to
the default values. Depending on the token used, the corresponding default values are set.
dot1x unauthenticated-vlan
Use this command to configure the unauthenticated VLAN associated with the specified interface or range of
interfaces. The unauthenticated VLAN ID can be a valid VLAN ID from 0-Maximum supported VLAN ID (4093 for
HP Moonshot Switch Module). The unauthenticated VLAN must be statically configured in the VLAN database
to be operational. By default, the unauthenticated VLAN is 0, i.e. invalid and not operational.
no dot1x unauthenticated-vlan
This command resets the unauthenticated-vlan associated with the port to its default value.
dot1x user
This command adds the specified user to the list of users with access to the specified port or all ports. The user
parameter must be a configured user.
Default • guest-vlan-period: 90 seconds
• reauth-period: 3600 seconds
• quiet-period: 60 seconds
• tx-period: 30 seconds
• supp-timeout: 30 seconds
• server-timeout: 30 seconds
Format
dot1x timeout {{guest-vlan-period seconds} |{reauth-period seconds} | {quiet-period
seconds} | {tx-period seconds} | {supp-timeout seconds} | {server-timeout seconds}}
Mode Interface Config
Format
no dot1x timeout {guest-vlan-period | reauth-period | quiet-period | tx-period | supp-
timeout | server-timeout}
Mode Interface Config
Default 0
Format
dot1x unauthenticated-vlan vlan id
Mode Interface Config
Format
no dot1x unauthenticated-vlan
Mode Interface Config
Format
dot1x user user {unit/slot/port | all}
Mode Global Config