Command Reference Guide

Storm-Control Commands
CLI Command Reference
September 2014 Page 354
HP Moonshot Switch Module CLI Command Reference
no storm-control broadcast rate
This command sets the broadcast storm recovery threshold to the default value for all interfaces (Global Config
mode) or one or more interfaces (Interface Config mode) and disables broadcast storm recovery.
storm-control multicast
This command enables multicast storm recovery mode for all interfaces (Global Config mode) or one or more
interfaces (Interface Config mode). If the mode is enabled, multicast storm recovery is active, and if the rate of
L2 multicast traffic ingressing on an interface increases beyond the configured threshold, the traffic will be
dropped. Therefore, the rate of multicast traffic will be limited to the configured threshold.
no storm-control multicast
This command disables multicast storm recovery mode for all interfaces (Global Config mode) or one or more
interfaces (Interface Config mode).
storm-control multicast level
This command configures the multicast storm recovery threshold for all interfaces (Global Config mode) or one
or more interfaces (Interface Config mode) as a percentage of link speed and enables multicast storm recovery
mode. If the mode is enabled, multicast storm recovery is active, and if the rate of L2 multicast traffic ingressing
on an interface increases beyond the configured threshold, the traffic will be dropped. Therefore, the rate of
multicast traffic will be limited to the configured threshold.
Format
no storm-control broadcast rate
Mode • Global Config
•Interface Config
Default disabled
Format
storm-control multicast
Mode • Global Config
•Interface Config
Format
no storm-control multicast
Mode • Global Config
•Interface Config
Default 5
Format
storm-control multicast level 0-100
Mode • Global Config
•Interface Config