Command Reference Guide

Storm-Control Commands
CLI Command Reference
September 2014 Page 355
HP Moonshot Switch Module CLI Command Reference
no storm-control multicast level
This command sets the multicast storm recovery threshold to the default value for all interfaces (Global Config
mode) or one or more interfaces (Interface Config mode) and disables multicast storm recovery.
storm-control multicast rate
Use this command to configure the multicast storm recovery threshold for all interfaces (Global Config mode)
or one or more interfaces (Interface Config mode) in packets per second. If the mode is enabled, multicast
storm recovery is active, and if the rate of L2 broadcast traffic ingressing on an interface increases beyond the
configured threshold, the traffic is dropped. Therefore, the rate of multicast traffic is limited to the configured
threshold.
no storm-control multicast rate
This command sets the multicast storm recovery threshold to the default value for all interfaces (Global Config
mode) or one or more interfaces (Interface Config mode) and disables multicast storm recovery.
storm-control unicast
This command enables unicast storm recovery mode for all interfaces (Global Config mode) or one or more
interfaces (Interface Config mode). If the mode is enabled, unicast storm recovery is active, and if the rate of
unknown L2 unicast (destination lookup failure) traffic ingressing on an interface increases beyond the
configured threshold, the traffic will be dropped. Therefore, the rate of unknown unicast traffic will be limited
to the configured threshold.
Format
no storm-control multicast level 0-100
Mode • Global Config
•Interface Config
Default 0
Format
storm-control multicast rate 0-14880000
Mode • Global Config
•Interface Config
Format
no storm-control multicast rate
Mode • Global Config
•Interface Config
Default disabled
Format
storm-control unicast
Mode • Global Config
•Interface Config