Command Reference Guide

Storm-Control Commands
CLI Command Reference
September 2014 Page 356
HP Moonshot Switch Module CLI Command Reference
no storm-control unicast
This command disables unicast storm recovery mode for all interfaces (Global Config mode) or one or more
interfaces (Interface Config mode).
storm-control unicast level
This command configures the unicast storm recovery threshold for all interfaces (Global Config mode) or one
or more interfaces (Interface Config mode) as a percentage of link speed, and enables unicast storm recovery.
If the mode is enabled, unicast storm recovery is active, and if the rate of unknown L2 unicast (destination
lookup failure) traffic ingressing on an interface increases beyond the configured threshold, the traffic will be
dropped. Therefore, the rate of unknown unicast traffic will be limited to the configured threshold.This
command also enables unicast storm recovery mode for an interface.
no storm-control unicast level
This command sets the unicast storm recovery threshold to the default value for all interfaces (Global Config
mode) or one or more interfaces (Interface Config mode) and disables unicast storm recovery.
storm-control unicast rate
Use this command to configure the unicast storm recovery threshold for all interfaces (Global Config mode) or
one or more interfaces (Interface Config mode) in packets per second. If the mode is enabled, unicast storm
recovery is active, and if the rate of L2 broadcast traffic ingressing on an interface increases beyond the
configured threshold, the traffic is dropped. Therefore, the rate of unicast traffic is limited to the configured
threshold.
Format
no storm-control unicast
Mode • Global Config
•Interface Config
Default 5
Format
storm-control unicast level 0-100
Mode • Global Config
•Interface Config
Format
no storm-control unicast level
Mode • Global Config
•Interface Config
Default 0
Format
storm-control unicast rate 0-14880000
Mode • Global Config
•Interface Config