Command Reference Guide

MVRP Commands
CLI Command Reference
September 2014 Page 365
HP Moonshot Switch Module CLI Command Reference
mvrp (Interface Config)
Use the mvrp command in Interface Configuration mode to enable MVRP mode on the interface. The port
should be configured in trunk or general mode. MVRP can be enabled on physical interfaces or LAG interfaces.
When configured on a LAG member port, MVRP is operationally disabled. Enabling MVRP on an interface
automatically enabled dynamic VLAN creation.
no mvrp (Interface Config)
Use the no mvrp command in Interface Configuration mode to disable MVRP mode on the interface.
clear mvrp
Use the clear mvrp command in Privileged EXEC mode to clear the MVRP statistics of one or all interfaces.
Default enabled
Format
mvrp
Mode Interface Config
Format
no mvrp
Mode Interface Config
Format
clear mvrp statistics [unit/slot/port | all]
Mode Privileged EXEC
Parameter Description
unit/slot/port If used with the unit/slot/port parameter, the command clears MVRP statistics for the given
interface.
all If the all parameter is specified, the command clears MVRP statistics for all the interfaces.