Command Reference Guide

Port-Channel/LAG (802.3ad) Commands
CLI Command Reference
September 2014 Page 375
HP Moonshot Switch Module CLI Command Reference
lacp partner admin state passive
Use this command to set the LACP partner admin state to passive.
no lacp partner admin state passive
Use this command to set the LACP partner admin state to active.
lacp partner port id
Use this command to configure the LACP partner port id. This command can be used to configure a single
interface or a range of interfaces. The valid range for
port-id is 0 to 65535.
no lacp partner port id
Use this command to set the LACP partner port id to the default.
Format
lacp partner admin state passive
Mode Interface Config
Note: This command is applicable only to physical interfaces.
Format
no lacp partner admin state passive
Mode Interface Config
Default 0x80
Format
lacp partner port-id port-id
Mode Interface Config
Note: This command is applicable only to physical interfaces.
Format
no lacp partner port-id
Mode Interface Config