Command Reference Guide

Port-Channel/LAG (802.3ad) Commands
CLI Command Reference
September 2014 Page 376
HP Moonshot Switch Module CLI Command Reference
lacp partner port priority
Use this command to configure the LACP partner port priority. This command can be used to configure a single
interface or a range of interfaces. The valid range for
priority is 0 to 65535.
no lacp partner port priority
Use this command to configure the default LACP partner port priority.
lacp partner system-id
Use this command to configure the 6-octet MAC Address value representing the administrative value of the
Aggregation Port’s protocol Partner’s System ID. This command can be used to configure a single interface or
a range of interfaces. The valid range of
system-id is 00:00:00:00:00:00 - FF:FF:FF:FF:FF.
no lacp partner system-id
Use this command to configure the default value representing the administrative value of the Aggregation
Port’s protocol Partner’s System ID.
Default 0x0
Format
lacp partner port priority priority
Mode Interface Config
Note: This command is applicable only to physical interfaces.
Format
no lacp partner port priority
Mode Interface Config
Default 00:00:00:00:00:00
Format
lacp partner system-id system-id
Mode Interface Config
Note: This command is applicable only to physical interfaces.
Format
no lacp partner system-id
Mode Interface Config