Command Reference Guide

Port-Channel/LAG (802.3ad) Commands
CLI Command Reference
September 2014 Page 377
HP Moonshot Switch Module CLI Command Reference
lacp partner system priority
Use this command to configure the administrative value of the priority associated with the Partner’s System ID.
This command can be used to configure a single interface or a range of interfaces. The valid range for
priority
is 0 to 65535.
no lacp partner system priority
Use this command to configure the default administrative value of priority associated with the Partner’s System
ID.
interface lag
Use this command to enter Interface configuration mode for the specified LAG.
port-channel static
This command enables the static mode on a port-channel (LAG) interface or range of interfaces. By default the
static mode for a new port-channel is enabled, which means the port-channel is static. If the maximum number
of allowable dynamic port-channels are already present in the system, the static mode for a new port-channel
is enabled, which means the port-channel is static. You can only use this command on port-channel interfaces.
Default 0x0
Format
lacp partner system priority 0-65535
Mode Interface Config
Note: This command is applicable only to physical interfaces.
Format
no lacp partner system priority
Mode Interface Config
Format
interface lag lag-interface-number
Mode Global Config
Default enabled
Format
port-channel static
Mode Interface Config