Command Reference Guide

Port-Channel/LAG (802.3ad) Commands
CLI Command Reference
September 2014 Page 378
HP Moonshot Switch Module CLI Command Reference
no port-channel static
This command sets the static mode on a particular port-channel (LAG) interface to the default value. This
command will be executed only for interfaces of type port-channel (LAG).
port lacpmode
This command enables Link Aggregation Control Protocol (LACP) on a port or range of ports.
no port lacpmode
This command disables Link Aggregation Control Protocol (LACP) on a port.
port lacpmode enable all
This command enables Link Aggregation Control Protocol (LACP) on all ports.
no port lacpmode enable all
This command disables Link Aggregation Control Protocol (LACP) on all ports.
Format
no port-channel static
Mode Interface Config
Default enabled
Format
port lacpmode
Mode Interface Config
Format
no port lacpmode
Mode Interface Config
Format
port lacpmode enable all
Mode Global Config
Format
no port lacpmode enable all
Mode Global Config