Command Reference Guide

Port-Channel/LAG (802.3ad) Commands
CLI Command Reference
September 2014 Page 383
HP Moonshot Switch Module CLI Command Reference
show lacp actor
Use this command to display LACP actor attributes. Instead of unit/slot/port, lag lag-intf-num can be used
as an alternate way to specify the LAG interface.
lag lag-intf-num can also be used to specify the LAG
interface where
lag-intf-num is the LAG port number.
The following output parameters are displayed.
show lacp partner
Use this command to display LACP partner attributes. Instead of unit/slot/port, lag lag-intf-num can be used
as an alternate way to specify the LAG interface.
lag lag-intf-num can also be used to specify the LAG
interface where
lag-intf-num is the LAG port number.
The following output parameters are displayed.
Format
show lacp actor {unit/slot/port|all}
Mode Global Config
Parameter Description
System Priority The administrative value of the Key.
Actor Admin Key The administrative value of the Key.
Port Priority The priority value assigned to the Aggregation Port.
Admin State The administrative values of the actor state as transmitted by the Actor in LACPDUs.
Format
show lacp actor {unit/slot/port|all}
Mode Privileged EXEC
Parameter Description
System Priority The administrative value of priority associated with the Partner’s System ID.
System-ID Represents the administrative value of the Aggregation Port’s protocol Partner’s System ID.
Admin Key The administrative value of the Key for the protocol Partner.
Port Priority The administrative value of the Key for protocol Partner.
Port-ID The administrative value of the port number for the protocol Partner.
Admin State The administrative values of the actor state for the protocol Partner.