Command Reference Guide

Port-Channel/LAG (802.3ad) Commands
CLI Command Reference
September 2014 Page 384
HP Moonshot Switch Module CLI Command Reference
show port-channel brief
This command displays the static capability of all port-channel (LAG) interfaces on the device as well as a
summary of individual port-channel interfaces. Instead of
unit/slot/port, lag lag-intf-num can be used as an
alternate way to specify the LAG interface.
lag lag-intf-num can also be used to specify the LAG interface
where
lag-intf-num is the LAG port number.
For each port-channel the following information is displayed:
show port-channel
This command displays an overview of all port-channels (LAGs) on the switch. Instead of unit/slot/port, lag
lag-intf-num
can be used as an alternate way to specify the LAG interface. lag lag-intf-num can also be used
to specify the LAG interface where
lag-intf-num is the LAG port number.
Format
show port-channel brief
Mode •Privileged EXEC
• User EXEC
Term Definition
Logical Interface The
unit/slot/port of the logical interface.
Port-channel Name The name of port-channel (LAG) interface.
Min The minimum number of links that must be up for the port channel to be up.
Link-State Shows whether the link is up or down.
Trap Flag Shows whether trap flags are enabled or disabled.
Type Shows whether the port-channel is statically or dynamically maintained.
Mbr Ports The members of this port-channel.
Active Ports The ports that are actively participating in the port-channel.
Format
show port-channel {unit/slot/port | lag-intf-num | all}
Mode •Privileged EXEC
• User EXEC