Command Reference Guide

Port-Channel/LAG (802.3ad) Commands
CLI Command Reference
September 2014 Page 386
HP Moonshot Switch Module CLI Command Reference
Example: The following shows example CLI display output for the command.
(Routing) #show port-channel 1
Local Interface................................ 0/3/1
Channel Name................................... ch1
Link State..................................... Down
Admin Mode..................................... Enabled
Type........................................... Static
Port-channel Min-links......................... 1
Load Balance Option............................ 3
(Src/Dest MAC, VLAN, EType, incoming port)
Mbr Device/ Port Port
Ports Timeout Speed Active
------ ------------- --------- -------
1/0/10 actor/long 10G Full False
partner/long
show port-channel system priority
Use this command to display the port-channel system priority.
show port-channel counters
Use this command to display port-channel counters for the specified port.
Format
show port-channel system priority
Mode Privileged EXEC
Term Definition
System Priority The LACP system priority of the switch. This value is used in negotiations with the partner
device.
Format
show port-channel lag-intf-num counters
Mode Privileged EXEC
Term Definition
Local Interface The valid slot/port number.
Channel Name The name of this port-channel (LAG).
Link State Indicates whether the Link is up or down.
Admin Mode May be enabled or disabled. The factory default is enabled.
Port Channel Flap
Count
The number of times the port-channel was inactive.