Command Reference Guide

Port Mirroring Commands
CLI Command Reference
September 2014 Page 389
HP Moonshot Switch Module CLI Command Reference
monitor session destination
This command configures a probe port or reflector port for a monitor session (port monitoring). The
destination port usually has a network analyzer attached. The
reflector-port is configured at the source
switch and forwards the mirrored traffic towards the destination switch.
Use the
destination interface unit/slot/port to specify the interface to receive the monitored traffic.
no monitor session destination
Use this command to remove the specified interface or reflector port from the port monitoring session.
.
monitor session mode
This command to enable the administrative mode of the session. If enabled, the probe port monitors all the
traffic received and transmitted on the physical monitored port.
no monitor session mode
Use this command to disable the port monitoring session.
.
Note: The source and destination cannot be configured as remote on the same device.
Note: The reflector port must be configured with RSPAN VLAN membership.
Format
monitor session session-id destination {interface unit/slot/port |remote vlan vlan-id
reflector-port unit/slot/port}
Mode Global Config
Format
no monitor session session-id destination {interface |remote vlan}
Mode Global Config
Format
monitor session session-id mode
Mode Global Config
Note: Since the current version of HP Moonshot software only supports one session, the behavior of
this command is similar to the behavior of the
no monitor command.
Format
no monitor session session-id mode
Mode Global Config