Command Reference Guide

Port Mirroring Commands
CLI Command Reference
September 2014 Page 390
HP Moonshot Switch Module CLI Command Reference
monitor session filter
Use this command to filter the traffic that is monitored. The ACL that is used to filter the traffic must already
exist on the system before it can be attached to the port monitoring session.
no monitor session
Use this command to remove the MAC or IP ACL filter from the port mirroring session.
no monitor
This command removes all the source ports and a destination port for the and restores the default value for
mirroring session mode for all the configured sessions.
Format
monitor session session-id filter {ip access-group acl-id/aclname |mac access-group
acl-name}
Mode Global Config
Format
no monitor session session-id filter {ip access-group | mac access-group}
Mode Global Config
Note: This is a stand-alone “no” command. This command does not have a “normal” form.
Default enabled
Format
no monitor
Mode Global Config