Command Reference Guide

Port Mirroring Commands
CLI Command Reference
September 2014 Page 391
HP Moonshot Switch Module CLI Command Reference
show monitor session
This command displays the Port monitoring information for a particular mirroring session.
Note: The session-id parameter is an integer value used to identify the session. In the current
version of the software, the
session-id parameter is always one (1).
Format
show monitor session session-id
Mode Privileged EXEC
Term Definition
Session ID An integer value used to identify the session. Its value can be anything between 1 and the
maximum number of mirroring sessions allowed on the platform.
Admin Mode Indicates whether the Port Mirroring feature is enabled or disabled for the session
identified with
session-id. The possible values are Enabled and Disabled.
Probe Port Probe port (destination port) for the session identified with
session-id. If probe port is not
set then this field is blank.
Src VLAN All member ports of this VLAN are mirrored. If the source VLAN is not configured, this field
is blank.
Mirrored Port The ports that are configured as the mirrored ports (source ports) for the session identified
with
session-id. If no source port is configured for the session then this field is blank.
Ref. Port The reflector port, which is the port that carries all the mirrored traffic from the source
switch toward the destination switch.
Src RVLAN The source VLAN is configured at the destination switch. If the remote VLAN is not
configured, this field is blank.
Dst RVLAN The destination VLAN is configured at the source switch. If the remote VLAN is not
configured, this field is blank.
Type Direction in which source port configured for port mirroring.Types are tx for transmitted
packets and rx for receiving packets.
IP ACL The IP access-list id or name attached to the port mirroring session.
MAC ACL The MAC access-list name attached to the port mirroring session.