Command Reference Guide

Static MAC Filtering Commands
CLI Command Reference
September 2014 Page 392
HP Moonshot Switch Module CLI Command Reference
show vlan remote-span
This command displays the configured RSPAN VLAN.
Example: The following shows example output for the command.
(Routing)# show vlan remote-span
Remote SPAN VLAN
------------------------------------------------------------------------
100
Static MAC Filtering Commands
The commands in this section describe how to configure static MAC filtering. Static MAC filtering allows you to
configure destination ports for a static multicast MAC filter irrespective of the platform.
macfilter
This command adds a static MAC filter entry for the MAC address macaddr on the VLAN vlanid. The value of
the
macaddr parameter is a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6. The restricted MAC
Addresses are: 00:00:00:00:00:00, 01:80:C2:00:00:00 to 01:80:C2:00:00:0F, 01:80:C2:00:00:20 to
01:80:C2:00:00:21, and FF:FF:FF:FF:FF:FF. The
vlanid parameter must identify a valid VLAN.
The number of static mac filters supported on the system is different for MAC filters where source ports are
configured and MAC filters where destination ports are configured.
• For unicast MAC address filters and multicast MAC address filters with source port lists, the maximum
number of static MAC filters supported is 20.
• For multicast MAC address filters with destination ports configured, the maximum number of static filters
supported is 256. You can configure the following combinations:
– Unicast MAC and source port (max = 20)
– Multicast MAC and source port (max = 20)
– Multicast MAC and destination port (only) (max = 256)
– Multicast MAC and source ports and destination ports (max = 20)
Format
show vlan remote-span
Mode Privileged Exec Mode
Format
macfilter macaddr vlanid
Mode Global Config