Command Reference Guide

Static MAC Filtering Commands
CLI Command Reference
September 2014 Page 393
HP Moonshot Switch Module CLI Command Reference
no macfilter
This command removes all filtering restrictions and the static MAC filter entry for the MAC address macaddr on
the VLAN
vlanid. The macaddr parameter must be specified as a 6-byte hexadecimal number in the format of
b1:b2:b3:b4:b5:b6.
The
vlanid parameter must identify a valid VLAN.
macfilter adddest
Use this command to add the interface or range of interfaces to the destination filter set for the MAC filter with
the given
macaddr and VLAN of vlanid. The macaddr parameter must be specified as a 6-byte hexadecimal
number in the format of b1:b2:b3:b4:b5:b6. The
vlanid parameter must identify a valid VLAN.
no macfilter adddest
This command removes a port from the destination filter set for the MAC filter with the given macaddr and
VLAN of
vlanid. The macaddr parameter must be specified as a 6-byte hexadecimal number in the format of
b1:b2:b3:b4:b5:b6. The
vlanid parameter must identify a valid VLAN.
macfilter adddest all
This command adds all interfaces to the destination filter set for the MAC filter with the given macaddr and
VLAN of
vlanid. The macaddr parameter must be specified as a 6-byte hexadecimal number in the format of
b1:b2:b3:b4:b5:b6. The
vlanid parameter must identify a valid VLAN.
Format
no macfilter macaddr vlanid
Mode Global Config
Note: Configuring a destination port list is only valid for multicast MAC addresses.
Format
macfilter adddest macaddr
Mode Interface Config
Format
no macfilter adddest macaddr
Mode Interface Config
Note: Configuring a destination port list is only valid for multicast MAC addresses.
Format
macfilter adddest all macaddr
Mode Global Config