Command Reference Guide

DHCP L2 Relay Agent Commands
CLI Command Reference
September 2014 Page 399
HP Moonshot Switch Module CLI Command Reference
show dhcp l2relay circuit-id vlan
This command displays DHCP circuit-id vlan configuration.
show dhcp l2relay interface
This command displays DHCP L2 relay configuration specific to interfaces.
Example: The following shows example CLI display output for the command.
(Routing) #show dhcp l2relay interface all
DHCP L2 Relay is Enabled.
Interface L2RelayMode TrustMode
---------- ----------- --------------
1/0/2 Enabled untrusted
1/0/4 Disabled trusted
show dhcp l2relay remote-id vlan
This command displays DHCP Remote-id vlan configuration.
Format
show dhcp l2relay circuit-id vlan vlan-list
Mode Privileged EXEC
Parameter Description
vlan-list Enter VLAN IDs in the range 1–4093. Use a dash (–) to specify a range or a comma (,) to
separate VLAN IDs in a list. Spaces and zeros are not permitted.
Format
show dhcp l2relay interface {all | interface-num}
Mode Privileged EXEC
Format
show dhcp l2relay remote-id vlan vlan-list
Mode Privileged EXEC
Parameter Description
vlan-list Enter VLAN IDs in the range 1–4093. Use a dash (–) to specify a range or a comma (,) to
separate VLAN IDs in a list. Spaces and zeros are not permitted.