Command Reference Guide

DHCP Snooping Configuration Commands
CLI Command Reference
September 2014 Page 405
HP Moonshot Switch Module CLI Command Reference
no ip dhcp snooping binding
Use this command to remove the DHCP static entry from the DHCP Snooping database.
ip verify binding
Use this command to configure static IP source guard (IPSG) entries.
no ip verify binding
Use this command to remove the IPSG static entry from the IPSG database.
ip dhcp snooping limit
Use this command to control the rate at which the DHCP Snooping messages come on an interface or range of
interfaces. By default, rate limiting is disabled. When enabled, the rate can range from 0 to 300 packets per
second. The burst level range is 1 to 15 seconds.
no ip dhcp snooping limit
Use this command to set the rate at which the DHCP Snooping messages come, and the burst level, to the
defaults.
Format
no ip dhcp snooping binding mac-address
Mode Global Config
Format
ip verify binding mac-address vlan vlan id ip address interface interface id
Mode Global Config
Format
no ip verify binding mac-address vlan vlan id ip address interface interface id
Mode Global Config
Default disabled (no limit)
Format
ip dhcp snooping limit {rate 0–300 [burst interval 1–15]}
Mode Interface Config
Format
no ip dhcp snooping limit
Mode Interface Config