Command Reference Guide

DHCP Snooping Configuration Commands
CLI Command Reference
September 2014 Page 406
HP Moonshot Switch Module CLI Command Reference
ip dhcp snooping log-invalid
Use this command to control the logging DHCP messages filtration by the DHCP Snooping application. This
command can be used to configure a single interface or a range of interfaces.
no ip dhcp snooping log-invalid
Use this command to disable the logging DHCP messages filtration by the DHCP Snooping application.
ip dhcp snooping trust
Use this command to configure an interface or range of interfaces as trusted.
no ip dhcp snooping trust
Use this command to configure the port as untrusted.
ip verify source
Use this command to configure the IPSG source ID attribute to filter the data traffic in the hardware. Source ID
is the combination of IP address and MAC address. Normal command allows data traffic filtration based on the
IP address. With the “port-security” option, the data traffic will be filtered based on the IP and MAC addresses.
This command can be used to configure a single interface or a range of interfaces.
Default disabled
Format
ip dhcp snooping log-invalid
Mode Interface Config
Format
no ip dhcp snooping log-invalid
Mode Interface Config
Default disabled
Format
ip dhcp snooping trust
Mode Interface Config
Format
no ip dhcp snooping trust
Mode Interface Config
Default
the source ID is the IP address
Format
ip verify source {port-security}
Mode Interface Config