Command Reference Guide

DHCP Snooping Configuration Commands
CLI Command Reference
September 2014 Page 407
HP Moonshot Switch Module CLI Command Reference
no ip verify source
Use this command to disable the IPSG configuration in the hardware. You cannot disable port-security alone if
it is configured.
show ip dhcp snooping
Use this command to display the DHCP Snooping global configurations and per port configurations.
Example: The following shows example CLI display output for the command.
(Routing) #show ip dhcp snooping
DHCP snooping is Disabled
DHCP snooping source MAC verification is enabled
DHCP snooping is enabled on the following VLANs:
11 - 30, 40
Interface Trusted Log Invalid Pkts
--------- -------- ----------------
1/0/1 Yes No
1/0/2 No Yes
1/0/3 No Yes
1/0/4 No No
1/0/6 No No
Format
no ip verify source
Mode Interface Config
Format
show ip dhcp snooping
Mode Privileged EXEC
Term Definition
Interface The interface for which data is displayed.
Trusted If it is enabled, DHCP snooping considers the port as trusted. The factory default is disabled.
Log Invalid Pkts If it is enabled, DHCP snooping application logs invalid packets on the specified interface.