Command Reference Guide

Dynamic ARP Inspection Commands
CLI Command Reference
September 2014 Page 419
HP Moonshot Switch Module CLI Command Reference
clear ip arp inspection statistics
Use this command to reset the statistics for Dynamic ARP Inspection on all VLANs.
show ip arp inspection interfaces
Use this command to display the Dynamic ARP Inspection configuration on all the DAI-enabled interfaces. An
interface is said to be enabled for DAI if at least one VLAN, that the interface is a member of, is enabled for DAI.
Given a
unit/slot/port interface argument, the command displays the values for that interface whether the
interface is enabled for DAI or not.
Example: The following shows example CLI display output for the command.
(Routing) #show ip arp inspection interfaces
Interface Trust State Rate Limit Burst Interval
(pps) (seconds)
--------------- ----------- ---------- ---------------
1/0/1 Untrusted 15 1
1/0/2 Untrusted 10 10
Default
none
Format
clear ip arp inspection statistics
Mode Privileged EXEC
Format
show ip arp inspection interfaces [unit/slot/port]
Mode •Privileged EXEC
• User EXEC
Term Definition
Interface The interface ID for each displayed row.
Trust State Whether the interface is trusted or untrusted for DAI.
Rate Limit The configured rate limit value in packets per second.
Burst Interval The configured burst interval value in seconds.