Command Reference Guide

IGMP Snooping Configuration Commands
CLI Command Reference
September 2014 Page 423
HP Moonshot Switch Module CLI Command Reference
no set igmp fast-leave
This command disables IGMP Snooping fast-leave admin mode on a selected interface.
set igmp groupmembership-interval
This command sets the IGMP Group Membership Interval time on a VLAN, one interface, a range of interfaces,
or all interfaces. The Group Membership Interval time is the amount of time in seconds that a switch waits for
a report from a particular group on a particular interface before deleting the interface from the entry. This
value must be greater than the IGMPv3 Maximum Response time value. The range is 2 to 3600 seconds.
no set igmp groupmembership-interval
This command sets the IGMPv3 Group Membership Interval time to the default value.
Default disabled
Format
set igmp fast-leave
Mode Interface Config
Format
no set igmp fast-leave vlan_id
Mode VLAN Config
Format
no set igmp fast-leave
Mode Interface Config
Default 260 seconds
Format
set igmp groupmembership-interval vlan_id 2-3600
Mode VLAN Config
Default 260 seconds
Format
set igmp groupmembership-interval 2-3600
Mode •Interface Config
• Global Config
Format
no set igmp groupmembership-interval [vlan_id]
Mode VLAN Config
Format
no set igmp groupmembership-interval
Mode •Interface Config
• Global Config