Command Reference Guide

IGMP Snooping Configuration Commands
CLI Command Reference
September 2014 Page 424
HP Moonshot Switch Module CLI Command Reference
set igmp header-validation
This command administratively enables IGMP header validation. When enabled, the switch validates the IP
header checksum and the IGMP header checksum. If checksum errors exist, the frame is discarded.
no set igmp header-validation
This command administratively disables IGMP header validation.
set igmp maxresponse
This command sets the IGMP Maximum Response time for the system, on a particular interface or VLAN, or on
a range of interfaces. The Maximum Response time is the amount of time in seconds that a switch will wait
after sending a query on an interface because it did not receive a report for a particular group in that interface.
This value must be less than the IGMP Query Interval time value. The range is 1 to 25 seconds.
no set igmp maxresponse
This command sets the max response time (on the interface or VLAN) to the default value.
Default Enabled
Format
set igmp header-validation
Mode Global Config
Format
no set igmp header-validation
Mode Global Config
Default 10 seconds
Format
set igmp maxresponse vlan_id 1-25
Mode VLAN Config
Default 10 seconds
Format
set igmp maxresponse 1-25
Mode • Global Config
•Interface Config
Format
no set igmp maxresponse vlan_id
Mode VLAN Config
Format
no set igmp maxresponse
Mode • Global Config
•Interface Config