Command Reference Guide

IGMP Snooping Configuration Commands
CLI Command Reference
September 2014 Page 428
HP Moonshot Switch Module CLI Command Reference
When you specify a value for vlan_id, the following information appears:
Example: The following shows example CLI display output for the command.
(Routing) #show igmpsnooping 1
VLAN ID........................................ 1
IGMP Snooping Admin Mode....................... Disabled
Fast Leave Mode................................ Disabled
Group Membership Interval (secs)............... 260
Max Response Time (secs)....................... 10
Multicast Router Expiry Time (secs)............ 0
Report Suppression Mode........................ Enabled
show igmpsnooping mrouter interface
This command displays information about statically configured ports.
Term Definition
VLAN ID The VLAN ID.
IGMP Snooping Admin
Mode
Indicates whether IGMP Snooping is active on the VLAN.
Fast Leave Mode Indicates whether IGMP Snooping Fast-leave is active on the VLAN.
Group Membership
Interval (secs)
The amount of time in seconds that a switch will wait for a report from a particular
group on a particular interface, which is participating in the VLAN, before deleting the
interface from the entry.This value may be configured.
Maximum Response
Time (secs)
The amount of time the switch waits after it sends a query on an interface,
participating in the VLAN, because it did not receive a report for a particular group
on that interface. This value may be configured.
Multicast Router Expiry
Time (secs)
The amount of time to wait before removing an interface that is participating in the
VLAN from the list of interfaces with multicast routers attached. The interface is
removed if a query is not received. This value may be configured.
Report Suppression
Mode
Indicates whether IGMP reports (set by the command “set igmp report-suppression”
on page 426) in enabled or not.
Format
show igmpsnooping mrouter interface unit/slot/port
Mode Privileged EXEC
Term Definition
Slot/Port The port on which multicast router information is being displayed.
Multicast Router
Attached
Indicates whether multicast router is statically enabled on the interface.