Command Reference Guide

IGMP Snooping Querier Commands
CLI Command Reference
September 2014 Page 432
HP Moonshot Switch Module CLI Command Reference
set igmp querier version
Use this command to set the IGMP version of the query that the snooping switch is going to send periodically.
no set igmp querier version
Use this command to set the IGMP Querier version to its default value.
set igmp querier election participate
Use this command to enable the Snooping Querier to participate in the Querier Election process when it
discovers the presence of another Querier in the VLAN. When this mode is enabled, if the Snooping Querier
finds that the other Querier’s source address is better (less) than the Snooping Querier’s address, it stops
sending periodic queries. If the Snooping Querier wins the election, then it will continue sending periodic
queries.
no set igmp querier election participate
Use this command to set the Snooping Querier not to participate in querier election but go into non-querier
mode as soon as it discovers the presence of another querier in the same VLAN.
show igmpsnooping querier
Use this command to display IGMP Snooping Querier information. Configured information is displayed
whether or not IGMP Snooping Querier is enabled.
Default 1
Format
set igmp querier version 1-2
Mode Global Config
Format
no set igmp querier version
Mode Global Config
Default disabled
Format
set igmp querier election participate vlan-id
Mode VLAN Config
Format
no set igmp querier election participate vlan-id
Mode VLAN Config
Format
show igmpsnooping querier [{detail | vlan vlanid}]
Mode Privileged EXEC