Command Reference Guide

MLD Snooping Commands
CLI Command Reference
September 2014 Page 436
HP Moonshot Switch Module CLI Command Reference
no set mld fast-leave
Use this command to disable MLD Snooping fast-leave admin mode on a selected interface.
set mld groupmembership-interval
Use this command to set the MLD Group Membership Interval time on a VLAN, one interface or all interfaces.
The Group Membership Interval time is the amount of time in seconds that a switch waits for a report from a
particular group on a particular interface before deleting the interface from the entry. This value must be
greater than the MLDv2 Maximum Response time value. The range is 2 to 3600 seconds.
Note: Fast-leave processing is supported only with MLD version 1 hosts.
Default disabled
Format
set mld fast-leave vlanid
Mode VLAN Mode
Default disabled
Format
set mld fast-leave
Mode Interface Config
Format
no set mld fast-leave vlanid
Mode VLAN Mode
Format
no set mld fast-leave
Mode Interface Config
Default 260 seconds
Format
set mld groupmembership-interval vlanid 2-3600
Mode VLAN Mode
Default 260 seconds
Format
set mld groupmembership-interval 2-3600
Mode •Interface Config
• Global Config