Command Reference Guide

MLD Snooping Commands
CLI Command Reference
September 2014 Page 437
HP Moonshot Switch Module CLI Command Reference
no set groupmembership-interval
Use this command to set the MLDv2 Group Membership Interval time to the default value.
set mld maxresponse
Use this command to set the MLD Maximum Response time for the system, on a particular interface or VLAN.
The Maximum Response time is the amount of time in seconds that a switch will wait after sending a query on
an interface because it did not receive a report for a particular group in that interface. This value must be less
than the MLD Query Interval time value. The range is 1 to 65 seconds.
no set mld maxresponse
Use this command to set the max response time (on the interface or VLAN) to the default value.
Format
no set mld groupmembership-interval vlanid
Mode VLAN Mode
Format
no set mld groupmembership-interval
Mode •Interface Config
• Global Config
Default 10 seconds
Format
set mld maxresponse vlanid 1-65
Mode VLAN Mode
Default 10 seconds
Format
set mld maxresponse 1-65
Mode • Global Config
•Interface Config
Format
no set mld maxresponse vlanid
Mode VLAN Mode
Format
no set mld maxresponse
Mode • Global Config
•Interface Config