Command Reference Guide

MLD Snooping Commands
CLI Command Reference
September 2014 Page 440
HP Moonshot Switch Module CLI Command Reference
When you specify a value for vlanid, the information that is displayed for an interface displays as well as the
two fields in the following table.
show mldsnooping mrouter interface
Use this command to display information about statically configured multicast router attached interfaces.
show mldsnooping mrouter vlan
Use this command to display information about statically configured multicast router-attached interfaces.
Group Membership Interval Shows the amount of time in seconds that a switch will wait for a report from
a particular group on a particular interface, which is participating in the VLAN,
before deleting the interface from the entry. This value may be configured.
Max Response Time Displays the amount of time the switch waits after it sends a query on an
interface, participating in the VLAN, because it did not receive a report for a
particular group on that interface. This value may be configured.
Multicast Router Expiry Time Displays the amount of time to wait before removing an interface that is
participating in the VLAN from the list of interfaces with multicast routers
attached. The interface is removed if a query is not received. This value may be
configured.
Term Definition
VLAN ID The VLAN for which MLD snooping data is displayed.
Report Suppression Mode The administrative mode of MLD report suppression.
Format
show mldsnooping mrouter interface unit/slot/port
Mode Privileged EXEC
Term Definition
Slot/Port The interface on which multicast router information is being displayed.
Multicast Router
Attached
Indicates whether multicast router is statically enabled on the interface.
Format
show mldsnooping mrouter vlan unit/slot/port
Mode Privileged EXEC
Term Definition
Slot/Port The interface on which multicast router information is being displayed.
VLAN ID Displays the list of VLANs of which the interface is a member.
Term Definition