Command Reference Guide

MLD Snooping Querier Commands
CLI Command Reference
September 2014 Page 445
HP Moonshot Switch Module CLI Command Reference
set mld querier election participate
Use this command to enable the Snooping Querier to participate in the Querier Election process when it
discovers the presence of another Querier in the VLAN. When this mode is enabled, if the Snooping Querier
finds that the other Querier’s source address is better (less) than the Snooping Querier’s address, it stops
sending periodic queries. If the Snooping Querier wins the election, then it will continue sending periodic
queries.
no set mld querier election participate
Use this command to set the snooping querier not to participate in querier election but go into a non-querier
mode as soon as it discovers the presence of another querier in the same VLAN.
show mldsnooping querier
Use this command to display MLD Snooping Querier information. Configured information is displayed whether
or not MLD Snooping Querier is enabled.
When the optional arguments
vlandid are not used, the command displays the following information.
Default disabled
Format
set mld querier election participate vlanid
Mode VLAN Config
Format
no set mld querier election participate vlanid
Mode VLAN Config
Format
show mldsnooping querier [{detail | vlan vlanid}]
Mode Privileged EXEC
Field Description
MLD Snooping
Qurerier Mode
The administrative mode of the MLD snooping querier on the switch.
Querier Address The IPv6 address which will be used in the IPv6 header while sending out MLD queries. It
can be configured using the appropriate command.
MLD Version The version of MLD that will be used while sending out the queries. This is defaulted to
MLD
v1
and it cannot be changed.
Querier Query
Interval
Shows the amount of time in seconds that a Snooping Querier waits before sending out the
periodic general query.
Querier Expiry
Interval
Displays the amount of time to wait in the Non-Querier operational state before moving to
a Querier state.