Command Reference Guide

LLDP (802.1AB) Commands
CLI Command Reference
September 2014 Page 453
HP Moonshot Switch Module CLI Command Reference
LLDP (802.1AB) Commands
This section describes the command you use to configure Link Layer Discovery Protocol (LLDP), which is defined
in the IEEE 802.1AB specification. LLDP allows stations on an 802 LAN to advertise major capabilities and
physical descriptions. The advertisements allow a network management system (NMS) to access and display
this information.
lldp transmit
Use this command to enable the LLDP advertise capability on an interface or a range of interfaces.
no lldp transmit
Use this command to return the local data transmission capability to the default
.
lldp receive
Use this command to enable the LLDP receive capability on an interface or a range of interfaces.
no lldp receive
Use this command to return the reception of LLDPDUs to the default value.
Default disabled
Format
lldp transmit
Mode Interface Config
Format
no lldp transmit
Mode Interface Config
Default disabled
Format
lldp receive
Mode Interface Config
Format
no lldp receive
Mode Interface Config